Return to Home Page -

[History] [Revise]Gun Track

The Gun Track is the "ladder" part attached to the bottom plate of the Proton Wand. On close inspection of a hero thrower, there are 2 machined discs, usually referred to as Gun Disks, attached the main pockets of the part, plus a piece of scrap metal acting as a shim beneath the V-hook. On a stunt wand, this shim is replaced with a third disc. The S-hook is attached to the Gun Track using the rear-most disc, inverted.

This broken GB1 stunt wand (above, right) offers a clear view of the Gun Track without any additional hardware attached.

This page was last edited by Alex Newborn on July 3, 2012, 3:14 pm
Link to this page:

Links Below This Category:

Proton Pack Part Names -
Attenuator -
Bar Graph -
Barrel Trigger -
Booster Frame -
Booster Plug -
Booster Tube -
Bumper -
Crank Generator (Gearbox) -
Cyclotron -
Electrostatic Dissipation Assembly (EDA) -
Filler Tubes -
Front Cylinder -
Gun Track Disks -
Gun Ears -
Gun Knobs -
Gun Mount -
Hydrogen Gas Actuator (HGA) -
Injectors -
Instrument Bar -
Ion Arm -
Ion Knob (Shock Mount/Knob) -
Motherboard -
N-Filter -
Power Cell -
Primary Power Distributor (PPD) -
Rear cylinder -
Ribbon Cable Clamp -
S-hook -
Slo-Blo -
Synchronous Generator (Spacer) - /
Trigger box -
Trigger tip -
V-hook -
Vents -

© 1998-2024 - Created by AJ Quick
"" is a registered Trademark of GBFans LLC.
"Ghostbusters" and "Ghost-Design" are registered Trademarks of Columbia Pictures Industries Inc.
Send Ghostbusters Fans an Email - - Jurassic Jeep - 65 Million Years in the Making -