Page 1 of 1
3d printed goggle build
Posted: March 27th, 2021, 1:21 pm
by Nerdy NotionZ
Started my build for a new set of goggles.
Printed in inland petg
printing the right side right now, and ordered metal thumb screws.
Any tips on adding the line 24 snaps?
Re: 3d printed goggle build
Posted: April 1st, 2021, 3:31 pm
by Nerdy NotionZ
Got my screws in from McMaster-Carr!
Re: 3d printed goggle build
Posted: April 1st, 2021, 3:38 pm
by Kingpin
Hmm, I wonder if a thumb screw that's about half the height of those would be a closer match:
The frame looks great though, and the transparent print/bright colours combo really gives me Kenner vibes.
Re: 3d printed goggle build
Posted: April 1st, 2021, 3:53 pm
by Nerdy NotionZ
Kingpin wrote: ↑April 1st, 2021, 3:38 pm Hmm, I wonder if a thumb screw that's about half the height of those would be a closer match:
The frame looks great though, and the transparent print/bright colours combo really gives me Kenner vibes.
Sadly the next size down is about half the size of the ones in the pic.
As for colors, these may end up a nice weathered blue and yellow
Re: 3d printed goggle build
Posted: April 2nd, 2021, 7:36 am
by Ectotainment
What if you just cut down the length of the threaded part of the thumb screw so they sit a little closer to the lenses?
Re: 3d printed goggle build
Posted: April 2nd, 2021, 6:39 pm
by Nerdy NotionZ
They thread all the way in. Just did that for the pic. Didnt want to put them all the way in, just to take them.out for paint
Re: 3d printed goggle build
Posted: April 5th, 2021, 10:00 pm
by Nerdy NotionZ
Re: 3d printed goggle build
Posted: April 6th, 2021, 1:48 am
by Kingpin
Impressive. Most impressive.
Re: 3d printed goggle build
Posted: April 13th, 2021, 4:27 pm
by Nerdy NotionZ