GBFans.com

Started my build for a new set of goggles.

Printed in inland petg







printing the right side right now, and ordered metal thumb screws.

Any tips on adding the line 24 snaps?

Got my screws in from McMaster-Carr!

Hmm, I wonder if a thumb screw that's about half the height of those would be a closer match:



The frame looks great though, and the transparent print/bright colours combo really gives me Kenner vibes.

Kingpin wrote: ↑April 1st, 2021, 3:38 pm Hmm, I wonder if a thumb screw that's about half the height of those would be a closer match:



The frame looks great though, and the transparent print/bright colours combo really gives me Kenner vibes.

Sadly the next size down is about half the size of the ones in the pic.

As for colors, these may end up a nice weathered blue and yellow

What if you just cut down the length of the threaded part of the thumb screw so they sit a little closer to the lenses?

They thread all the way in. Just did that for the pic. Didnt want to put them all the way in, just to take them.out for paint

Finished the body for my Vault 84 Ghostbusters Ecto Googles
Just need to make the strap and add lenses into the sockets.

Impressive. Most impressive.

Almost done. Just got to make the lenses.