By Daveakins1
#4927386
Hi all,
Just about finished my spirit Halloween proton pack. I did a 3d printed neutrino wand and it's great, but 3d printed is delicate compared to fiberglass and resin. Used mostly gb fans parts along with benofkent props.
Not the absolute best build, but it was fun and will in the future build a 1:1 scaled in the few years to come. Great overall for mancave feature and conversation piece starter. Fiance approved lol.
I dont mind comments, questions, or even sarcasm about it. Cost to build for everything was around the $700 range and labor wise was about 30 hours roughly to piece together. I dont have too much in the way of pics during the build, but only have a youtube link. Not trying to advertise anything at all.
Here is the link:
https://youtu.be/YqE--BaMrU0

Until we sit down and watch this, the movie is sim[…]

I thought I also remembered reading it somewhere[…]

New guy from Michigan

https://i.ibb.co/T0Wp6MF/EE3-C400-C-51-A0-41-A0-8[…]

Anyone around Detroit?

https://i.ibb.co/qyYzD2V/5-D4217-F6-91-EC-476-F-B[…]