[armysgt1]

I have a nice pioneer 6x9 4 ohm speaker ( Model TS-A6886-R ) that crackles and just sounds bad when the volume goes slightly past 50%. It really sounds bad when the power down sequence is activated, like there's way too much bass being put through the speaker. It sounds perfect up until that volume. I've tried both speakers in the package and they are the same. I have a fully charged 6400mah blue brick battery if that helps. Or would it really sound better with a single 8 ohm speaker? The only problem is I can't find any 8 ohm speakers anywhere around me besides online. I am going to connect both speakers and see how that sounds but obviously there's no room for 2 6x9 speakers. I'm looking for the best option here. Thanks guys.

[WindDrake]

It's crackling because the amp is starting to overdrive.

You should be able to add an amp in series no problem .

[armysgt1]

Ok thank you. So do I wire it straight from the two speaker terminals ? Sorry, I'm not that versed on audio hookups, just computers.

[likesjellydonuts]

Which sound kit do you have? Is it the newer one with the sound stored on an sd card, out the previous release?

[armysgt1]

The newer one with the SD card.

[armysgt1]

So I read somewhere on here that you can add an amp to the gbfans soundboard as long as it supports preamped input. How can I tell if it supports that? Has anybody else added and amp to the gbfans soundboard?

[jt614dta]

Was there ever a solution to this I'm having the same issues? Thanks