#4914160
starburst wrote: February 15th, 2019, 6:22 am Labels look great, definitely interested in seeing your results with the brush effect when you get to it.

Getting close to completion now by the looks of it!
just waiting on replacement parts for the electronics, once I get those fitted ( hard part) I just need stickers on the wand and a few bits glue on and then its done really. All that would be left to do is weathering :D
#4918240
dsource wrote: May 20th, 2019, 5:39 am
CorfieldUK81 wrote: May 7th, 2019, 7:54 am updating the cable to be a GB1 pack :D

Image
Nice work! How/ where did you find/make the GB1 cable? I've searched high and low in Australia and can't find anything similar anywhere. Any suggestions?
https://www.facebook.com/EPICPROPS/ is where I got mine, Finchers I believe is the known place get them, but I went with Epic as we were both UK based. Give him a shout

The yellow parts are raw 3D prints, unsanded and u[…]

Sorry, I hadn't seen any of these replies. Either […]

Uniform Tips

Sorry for the triple post (you guys have gotten […]

Proton Props???

Ugly Little Spud, Did you actually get the pack?[…]