[Sl!mer]

Finally got my Anovos proton pack frame in, and it didn't include the hardware to connect to the pack. Kind of an important thing to include. I tried going to Lowe's and they weren't helpful. Does anyone here sell or know where I can purchase the hardware online? Thanks.

This is what the Anovos instructions called for:
3x 1/4"-20 x 1.5/8" machine hex bolts
6x 3/8" flat washers
3x 1/4"-20 hex nuts
1/2 aluminum tube with 0.500 outside diameter and 0.430" inside diameter. Cut the 1/2" aluminum tube into 3 7/8" length sections

[mike_waclo]

I used these spacers: https://www.widgetco.com/14-by-1-inch-aluminum-spacers and slightly longer bolts than the Anovos instructions ask for. When I built my pack, they hadn't released the frame instructions yet, so I winged it based on reference photos here.

If you want to stick to their bolt dimenstions, you could use these spacers instead: https://www.widgetco.com/14-by-3-4-inch ... um-spacers But, from looking at photos, I think the 1" spacers will look more accurate to a GB2 pack.

I believe I used 2" bolts, and I used lock nuts to do the installation, to help make sure the nuts wouldn't be going anywhere during use. Nuts bolts and washers were very easy to find at Home Depot.

Here are a few shots of the mountings on my frame:

[Sl!mer]

Thank you! That worked out great.