[Mattb1Stantz]

Hi guys.

I'm working on a new shell based on Stefan drawings and all the information of the proton pack in Sony Lobby.

Here some preview:





I'll insert some information like the dimensions of the rings of the cyclotron (the upeer rings are bigger than the lower...) and the corret dimensions of the center cover.

If u have some more information about other changes between real pack anche the stefan otto's drawing please tell me.
After the shell has done I can give copy of the drawings to the community

[GBDRE760]

Nice!!!!

[Kingpin]

Looking good so far.

I'll have to refresh myself with the photos of the Super Hero Pack, but I believe the 45-degree chamfer on the bottom left corner of the doesn't actually go all the way down, but gradually terminates.

[err404]

Yup, all of the references that I have seen have this line fading out to square about an inch or so above the base. However this is nearly unnoticeable on a built pack being black and obscured by the booster tube, ribbon and support bracket.

[Demon Vice Commander]

Your drawing is looking pretty good - you might have a look at some of the photos that I took of the Venkman hero pack a few years ago for additional reference.

viewtopic.php?t=39517

[Mattb1Stantz]

Fresh news... project is near to be completed

[Mattb1Stantz]

Some more work on the 3D Project.











I've also stamped in 3D the gear box, gun mount cornerplate and the cyclotron.
The parts will made by my hands.