Page 1 of 1

Request: Rabid Prototypes Proton Pack Kit Diagram

PostPosted:October 17th, 2019, 11:40 am
by BlueChainsawMan
So...I just received my kit today. Just the kit in the box, no diagram to help with wiring. The website doesn't have any help on their end. Does anyone have photos of or a diagram of any kind to show where the switches and buttons go on the board? Of course there are the obvious labeled bits.

Image

Re: Request: Rabid Prototypes Proton Pack Kit Diagram

PostPosted:October 17th, 2019, 1:46 pm
by Kingpin
I'm sorry to read that, although I can't say I'm the least bit surprised knowing a bit of Shawn's previous history here. Hopefully a fan will be able to assist you by providing a guide for which components go where.

Re: Request: Rabid Prototypes Proton Pack Kit Diagram

PostPosted:October 17th, 2019, 7:45 pm
by Prologic9
If you'll scroll down on the product page it does have instructions for the switches and operation. Everything else is labeled on the board or has a unique connection (i.e. There are 5, 4, and 3 pin ribbons, they go in the 5,4,3 pin sockets. Etc.)

Re: Request: Rabid Prototypes Proton Pack Kit Diagram

PostPosted:October 18th, 2019, 9:13 am
by BlueChainsawMan
If you'll scroll down on the product page it does have instructions for the switches and operation. Everything else is labeled on the board or has a unique connection (i.e. There are 5, 4, and 3 pin ribbons, they go in the 5,4,3 pin sockets. Etc.)
Yeah I saw after I posted in the thread...


The ports are assigned as follows:

1. Activate – Long lead toggle on the left side of the thrower.
2. Capture stream – Black button on the left side of the thrower.
3. Grille – Short lead toggle near the top of the bargraph.
4. Mode – Short lead toggle by the bottom of the bargraph.
5. Blast steam – Red button on the ear at the tip of the thrower.
6. Not used!