My name is Azuma. I registered and became a member here in 2016, the same year I got my first back built, and I had my second one built in 2018. Both of my packs are equipped with Matty wand. For some reason, I am not satisfied with my both packs, so earlier this year I decided to commission someone to create a proton pack 3D model so that I can have my idealized pack made.
My pack is based on the measurements from Stefan’s plan with few correction, and the inside of the pack is made to my design. Because of my previous pack building experience, this pack is designed for friendly and easy installation. Slots and installation adapters are specially designed for GhostLab42 (Spongeface) light and sound boards. All holes are marked, and most of them are pre-drilled. The shell is 4mm thick, and 3D printed of AA Acrylic Acid, so sanding is not necessary and is ready for priming.
I am plan to make some available after I got the laser cut MB back. Don’t know if anyone here is interested?