Page 1 of 1

Spacer length between MB and Alice frame?

Posted: October 14th, 2020, 5:06 pm
by Darth_Egon
Guys what is the correct length of
The spacers for the packs?

Re: Spacer length between MB and Alice frame?

Posted: October 14th, 2020, 7:57 pm
by JWils23
I believe (and if I’m wrong hopefully someone will chime in) that they were 1” in both movies. In GB1 they were the black rubber spacers and in GB2 they were swapped out for just regular steel spacers.

Re: Spacer length between MB and Alice frame?

Posted: October 14th, 2020, 8:12 pm
by Darth_Egon
Cool I thought the bottom two were one inch and the top on was 3/4 of an inch.

Re: Spacer length between MB and Alice frame?

Posted: October 14th, 2020, 8:30 pm
by JWils23
I just measured the GB1 set I have from Joe Luna who’s using Nickatrons old molds and the bottom are 1”, the top is actually 1 3/16”.

Re: Spacer length between MB and Alice frame?

Posted: October 14th, 2020, 8:38 pm
by Darth_Egon
Awesome!!!!!

Re: Spacer length between MB and Alice frame?

Posted: October 14th, 2020, 10:16 pm
by Glenn Frederick
JWils23 wrote:I just measured the GB1 set I have from Joe Luna who’s using Nickatrons old molds and the bottom are 1”, the top is actually 1 3/16”.


When you measured the top spacer did you measure the end to the curve? I made spacers out of Hockey pucks and didn't realized that the groove in the spacer sits the frame to the motherboard at 1". That extra length of rubber curves around the groove on the bar of the frame, so the frame can mount flush in the spacer. If using steel spacers I believe all three spacers should be the exact length.

Re: Spacer length between MB and Alice frame?

Posted: October 16th, 2020, 9:20 am
by JWils23
I’ll take some pictures a little later today of the measurements of my spacers for reference!

Re: Spacer length between MB and Alice frame?

Posted: October 19th, 2020, 12:19 pm
by JWils23
Completely forgot to upload these this weekend, my bad!
Image
Image
Image
Image

Re: Spacer length between MB and Alice frame?

Posted: October 19th, 2020, 1:22 pm
by Darth_Egon
Awesome thank you!!!!