[Darth_Egon]

Hey guys is there a found part for the bracket on the side booster tubes or does it need to be fabricated?

[RedSpecial]

Its a fabricated piece.
You could use something off the shelf if the dimensions are correct but its easy enough just to bend some flat aluminium stock, drill a few holes and round off one end

[Darth_Egon]

Any chance do you know what the dimensions of that part is?

[RedSpecial]

The overall length and placement of the bend will depend on your pack measurements but I used a piece of 3mm thick aluminium plate thats about 40mm wide and 120mm long

[Darth_Egon]

Thank you very much!!!

[RedSpecial]

No problem