#4955730
It's got the overheat sequence? Could you post a video of that?

The sequence is going to be built into the electronics' circuit board... There isn't really a way to remove it other than to take the whole electronics rig out, and maybe substitute it for one of the rigs from one of the older Spirit Packs.
kahuna900 liked this

    The yellow parts are raw 3D prints, unsanded and u[…]

    Sorry, I hadn't seen any of these replies. Either […]

    Uniform Tips

    Sorry for the triple post (you guys have gotten […]

    Proton Props???

    Ugly Little Spud, Did you actually get the pack?[…]