- January 22nd, 2020, 8:04 pm#4930260
I'm thinking about 3d printing a trap but I think I want to do a GB2 version to match my pack. Has anyone 3d printed this version? I have seen lots of GB1s floating around.
- January 23rd, 2020, 8:27 am#4930285
There's minimal difference between the 2. If looking down on it, The knob on the right is now a silver barrel shaped and the side bars on the left are silver instead of red. So you could just print the trap and then customize it to GB2
"So your alien had a room at the Holiday Inn Paramus?"
www.facebook.com/seoghostbusters "Serving Southeast Ohio since 2011."
www.facebook.com/seoghostbusters "Serving Southeast Ohio since 2011."
- January 23rd, 2020, 12:02 pm#4930310
That's a good idea. I could do that. Wasn't it also a bit smaller?
- January 27th, 2020, 1:16 am#4930490
I used Countspatula files on Thingiverse. He includes the GB2 specific parts in the files too.
https://www.thingiverse.com/thing:1394492
I used Countspatula files on Thingiverse. He includes the GB2 specific parts in the files too.
https://www.thingiverse.com/thing:1394492
- By DarthNeroHow was it resolved?
Oldest Pack? (And other lefty’s?)
- By pda4everOh, another thing - this was made mostly out of sc[…]
Beautiful!! I'm getting this even if finances don[…]