https://www.amazon.com/uxcell-Mini-Elec ... 72&sr=8-15
There is one for each door.
They both run on a set of 4 9v batteries running in series which hide in the bottom of the trap between the wheels.
The wireless is a latch button:
The button key will eventually be put into an RGB style pedal, but in black to match the athstetic.
When the wireless pin goes high, the signal is sent to 2 separate relays which fit between the rear wheels of the trap.
https://www.amazon.com/Tolako-Arduino-I ... B00VRUAHLE
I didn't use a double relay because 2 of these fit perfectly in either side of the trap individually.
*I have made no modifications to the shell of the trap
*The main modifications have been:
- a dpdt bat toggle switch so the original circuit operates on its own
-the circuit board for the sound has been moved and attached right against the speaker bay (does not impede operation)
-The gear mechanism has been cut in half, springs removed, and pulley doors reversed to catch the solenoid poles.
-One of the pulley doors has a screw running through it to touch the limit switch of the original circuit so it operates the same way
However, both banks of 9v batteries die after about 30-40 minutes of trap use. (maybe opening and closing the trap about 10-12 times)
The solenoids are 12 volts, and 2amps.
The 2 amps has been the issue in finding a battery replacement that fits inside the trap without modifying the shell.
Does anyone have any input? (Sorry I don't have pictures!)