Have a guide or tutorial? Post it up!
By Paco
#4916860
is there a tutorial on how to wire up the shop supplied power battery to the pack lights? ive been looking online and zippo.
By jpetrutis81
#4916865
On the powercell/pack light board there is a blue block with two set screws. It is marked as "Pos" and "Gnd." You would need a stretch of wiring with bare ends on one side and preferably an adapter to connect to the blue brick otherwise you would have to cut off the male end of the battery. Not sure coming off the battery which wire would constitute the positive or the ground though. I am using a Spengler plate with wires (courtesy of NStevic01) to connect the brick to my Matty Blaster soundboard but the bare-wire hookup would be similar. http://www.gbfans.com/forum/viewtopic.php?f=31&t=35806
NEW GB MOVIE SUMMER 2020!

I don't have the money to buy a new system so I'm […]

Hello, here is the discussion thread for the upcom[…]

Evi’s Spirt Pack

Little more progress but that’s it for today[…]

Sprit Halloween pack

Thank you for your responce Kingpin. Is acrylic […]