Have a guide or tutorial? Post it up!
User avatar
By jreverhart
#4908319
This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.

lapena77 wrote: September 2nd, 2018, 3:12 pm What size of screws can I use to mount all electronics, I using electronics form GB fan shop
Howdy, I used these
https://www.amazon.com/gp/product/B073Z ... UTF8&psc=1

and used epoxy putty to attach the risers then used a short riser on the top. I attached all my electronics to the shell, so when i removed it I reduced the risk of yanking on the wires, and easier to line up the lights better. but its a preference but should work the same.

I've seen others just use like #6 nuts and bolts to mount aluminum plates and then use risers from there off the board. its really up to you whats easier. I tried to drill as few holes as possible in the MOBO (not including the speaker holes)
jpetrutis81 liked this
    Matty PKE Question...URGENT

    Depending on the price, it might be worth snatchin[…]

    I have a full sized spirit pack, and I have the gh[…]

    If you need any clarification at all, PM me or […]

    Proton Props UK

    Good decision to lift the ban! By the way: I think[…]