Post pictures up of your Props, or a link to your prop gallery on Ghostbusters Fans.
By YouCanStantz
#4936762
Hey now! I'm in the middle of fixing up 3 spirit packs and was wondering if anyone has replaced the tubing from pack to wand? Any recommendations on something less stiff? Thanks!
User avatar
By eastern57
#4937505
You can use Shower Hose. I got some fro home depot. It's a little thinner, about 0.5" (as opposed to the 1" Spirit stock), but it's SUPER flexible and way tougher.
https://www.homedepot.com/p/American-St ... /307246990

Otherwise, you can just cut the Spirit hose to make it split loom. The advantage here is that it's free, you don't even have to detach it, and you get a little more flexibility out of it.

I'd say try cutting the stock hose first, if that's not flexible enough, then you can always replace it with the shower hose.

    The yellow parts are raw 3D prints, unsanded and u[…]

    Sorry, I hadn't seen any of these replies. Either […]

    Uniform Tips

    Sorry for the triple post (you guys have gotten […]

    Proton Props???

    Ugly Little Spud, Did you actually get the pack?[…]