Page 1 of 1
Heat Sinks for Pump Boxes
Posted: August 2nd, 2014, 7:07 am
by goldenhawk
Has anyone made a resin cast or figured out where to get the heat sinks for the pump boxes? I need them to finish my Slime Blower.
Thanks.
Re: Heat Sinks for Pump Boxes
Posted: August 2nd, 2014, 8:21 am
by Kingpin
The real heat sink has not yet been identified. I think Nickatron did offer a limited run of resin heat sinks, but he doesn't appear to be producing them at the moment.
Re: Heat Sinks for Pump Boxes
Posted: September 15th, 2014, 6:27 pm
by goldenhawk
This post may contain an affiliate link that helps support GBFans.com when you make a purchase at no additional cost to you.Found them on ebay:
http://www.ebay.com/itm/171321400212?_t ... EBIDX%3AIT I bought four. Two for each pump box.
Re: Heat Sinks for Pump Boxes
Posted: October 27th, 2014, 12:51 pm
by Wildcard
It is possible to print...
Re: Heat Sinks for Pump Boxes
Posted: October 31st, 2014, 11:51 pm
by Turbomini73
That printed one is fantastic are you willing to share the file?
Re: Heat Sinks for Pump Boxes
Posted: November 3rd, 2014, 8:17 pm
by Wildcard
At the current time, no. Sorry!
I'm planning on selling parts once I hit 50 posts here
Re: Heat Sinks for Pump Boxes
Posted: November 5th, 2014, 12:27 pm
by Wildcard
Btw, while i haven't gotten a new crucible yet, I have thought about how to use a print to make and aluminum casting. Something that will probably take a while, but in the realm of possibility