- April 21st, 2020, 6:23 pm#4933879
I have a project i am working on for the game American truck simulator.
I am bringing Ecto-1 to game.
But my modeling talents are not all that good.
I have the model shown below, and work is going real good at converting it to an ecto 1.
I need some help.
If anyone here can model in 3d. i could use the spotlight mount made.
I can furnish the car to work with, as well as some of the aquired pieces to make ecto-1, in trade for the work.
Thanks
Craig.
The piece i need made.
And the work completed so far.
I am bringing Ecto-1 to game.
But my modeling talents are not all that good.
I have the model shown below, and work is going real good at converting it to an ecto 1.
I need some help.
If anyone here can model in 3d. i could use the spotlight mount made.
I can furnish the car to work with, as well as some of the aquired pieces to make ecto-1, in trade for the work.
Thanks
Craig.
The piece i need made.
And the work completed so far.
cristovalc liked this
- By alphabeta001
- By Christof
- By 13th Floor
- By robbritton