- June 12th, 2020, 5:33 pm#4935747
Hey,
I've no doubt this has been covered before, but anyone any tips on how to make a Garrett figure?
M
I've no doubt this has been covered before, but anyone any tips on how to make a Garrett figure?
M
- June 13th, 2020, 2:18 pm#4935774
Trendmasters did make a prototype figure of him and there a decent amount of photos of it on the web. Best way to do it would model it in a 3D modeling program and have it printed. You could go old school and sculpt one and have it cast in resin.
HasLab Plasma Series Neutrona Wands | Voltage Readouts??
- By pda4everI missed out on the Haslab packs too. I am conside[…]
- By UncannyGirlThanks The_Y33TER ! Confirmation there's no elect[…]
- By KingpinA little sneak preview of one of the bedrock parts[…]
Ghostbusters: Frozen Empire Proton Pack Research
- By kahuna900Where do the other ends of the red/yellow wire[…]