Don't quite understand Instagram yet, but...: thatnerdinatie
Founder (and so far sole member) of the Borderlands Ghostbusters
I have dual extrusion heads... And I took one off... I've found that the second head can drag on the work piece.That's one of the beauties of the Stratasys machines. It has a toggle head assembly, and actually raises and lowers the active nozzle by a few mm depending on which one is currently printing. Just enough to stay clear 99% of the time.
I only install the second tip when I am printing in two colors.
Perhaps I can get special permission to sell casts here since they are so hard to come by.Although your aim is noble, I'm afraid we do not grant special permission to sell items when a seller doesn't meet the requirements.
Yeah... I'll never meet these requirements. I'll find somewhere else to sell them. It's a shame gbfans is so restrictive on such matters. It took me about 6 months to find a redman and I would have killed for the chance to buy a cast.Unfortunately, just because you have something... it doesn't give you special treatment above all the others who do meet the requirements.
It's not restrictive, really. Your post count and time on the board let buyers know you intend to stick around, and a membership can be obtained by simply contributing information on the wiki pages; your info on the Redman buffer in the wiki could earn your membership. It'd be a shame to see a good product and potentially good seller refuse service on such simple grounds.This very much so.
Careful guys. Looks like plot leaks are out onlin[…]
I should also be noted that a 3d printed pack will[…]
I really had my hopes up for a giga meter. Not tha[…]
Ok figured it out! Theres a component labeled Q5 o[…]