- January 2nd, 2019, 2:48 pm#4911665
To those who have experience with 3d printed parts:
I just got a Ben of Kent 80% Neutrona Wand for my spirit pack, and I was wondering about the textured surfaces of some of the 3d printed parts.
Is it common to sand them for a more natural finish?
Thanks!
Joe Z
I just got a Ben of Kent 80% Neutrona Wand for my spirit pack, and I was wondering about the textured surfaces of some of the 3d printed parts.
Is it common to sand them for a more natural finish?
Thanks!
Joe Z