Why did they put Slimer in charge of that?!
EDIT: And after sitting in processing hell for a week in a half, this morning I get an email saying it's been shipped and will arrive today. I guess Slimer noticed my joke and sped things up.
Awesome news Fritz, let us know what you think of them after you get them.They actually arrived later that day, but I was a bit busy with other things to deal with them immediately.
Like the joints and the stream and everything else feels solid.....struggling w/ ordering another w/ a perfect logo, doing a kitbash, then returning the defective logo........what I cleaned up looks ok enough from two feet away but I know it's a botched logo....internal struggle w/ my mind more or less I think.You did a great job fixing the logo, especially considering how botched it was.
Man, I've had some seriously bad luck with Wave 8. On my first purchase, Venkman and Winston's hands snapped off at the pegs. DST replaced them (after far too many emails chasing them down, and about a month). And then Winston's hand snapped off again on the new one. Really sucks that they can't get these working better.So what you're saying is like Ghostbusters 3 Bill Murray is very ... Hands off!
And yes, I know about heating up the arms to loosen the hand pegs a bit. I've never had an issue prior to this wave, but it has me scared to even try anymore.
Should be good news for RGB........ https://www.previewsworld.com/Article/2 ... ember-2018
Should be good news for RGB........ https://www.previewsworld.com/Article/2 ... ember-2018This is good news. I hope the next series follows suit. I think we will see RGB carry into 2019 and hopefully lead up to possible figures for the 2020 movie. I hope DST can get that license. I also hope the success of the line brings in enough money to warrant getting the license for the ghosts from GB2, which is apparently separate.
I find myself in the position of having a We're Back with a broken thrower hose (disconnected from the Proton Gun handle). I'm after repair techniques/guidance... So far the main techniques I've encountered are drilling, or using a drawing pin to make a hole for a hose... But I'm keen to hear from folks who've actually done these as to how effective they are.I've had two break at the thrower right out of package. What I've started doing is using an xacto knife and boring a joke in the thrower handle. Then I replace the plastic cord completely with an elastic one that I have extra of from doing ring ropes on a wrestling ring.
There's no way that they don't at least have the Diorama and RGB figures on display, still waiting to see what's going on.Well, there really isn't reason to have the figures already being released at the show. Series 10 already shipped. This show is for media and buyers, not really fans like SDCC is. That's why there are no show exclusives like you see with CONs. It's a trade show.
Stay Puft looking pretty ugly.. Definitely milkin[…]
Donut Donut who? Donut open until Dooms[…]
I wouldn't even be surprised if the GB1 ribbon c[…]
Amazing attention to detail. Glad to hear your ba[…]