- June 17th, 2019, 8:04 pm#4919556
I'm finally starting my first build of a full-size pack. I have a GBFans shell and motherboard. Today I started to mark out where the mounting brackets should go before I start drilling the brackets (the whole measure twice, cut once mentality). When I looked around the motherboard for alignment I noticed a decent gap at the bottom of the shell. I don't think the shell necessarily warped but either way there is a gap. I am looking for wisdom from the group if it would be better to sand the shell to get a more flush fit or to use bondo or something similar to fill the gap? This area is the only area with a noticeable gap. If sanding would be the better option any ideas on how best to accomplish that (evenly) would be greatly appreciated. Thanks!