By Theron
#4922861
Hello,

I’ve seen several builds that had wand venting in addition to the N-filter vent kit provided by Jimfin. Does anyone have any information on how to incorporate wand venting? I’ve tried searching the forums with no luck and no luck with contacting Fincher Tech on Facebook. Thanks in advance.
By signeddiamond
#4922974
You would probably want 2 cig setups in the pack. One would not include the pc fan blower assembly and would only include the cig and main pump. Route this with some vinyl tubing to the thrower. Hypothetically you could do this with a single smoker but the output for each end would be drastically reduced.

Heading down to the IMAX to check this out today! […]

In a way, I'm also sad. It was fun to jump[…]

3D printed Proton Pack project

Those prints are looking nice and clean! Keep it u[…]

Ecto Goggles Build

I am super stoked that the community is enjoying t[…]