- August 25th, 2019, 2:38 am#4923133
Hello all. I've had my pack under repairs as the "builder" who made it was less then an ace (see feedback index) and while the local prop fellow I hired did a great job repairing a lot of it and fixing some issues there are some things he couldn't fix mostly because he didn't build it and didn't want to damage it because he didn't know how some things were done. Long story short there is a gap at the top of my pack between the shell and the motherboard. It's only present on the right hand (thrower) side and middle. The left sideis good but from the middle of the pack to the right side there's a small gap(I think if the allan screw was higher on the right side it would be fine but because it's mounted lower on that side the gap exists) I've had people suggest gently bending the motherboard with a vice on that side and some say use a clamp and secure the shell to the board and heat both with a hair dryer on hot for 10 min and leave to cool overnight. Shell and motherboard are from Ben of Kent. Has anyone else run into this and done these types of fixes or suggest something else?
-Thanks
-Thanks
"Well that's fine Louis...we got arrested at night" *head slam*