User avatar
By Kodee-Wan
#4930260
I'm thinking about 3d printing a trap but I think I want to do a GB2 version to match my pack. Has anyone 3d printed this version? I have seen lots of GB1s floating around.
User avatar
By DarkSpectre
#4930285
There's minimal difference between the 2. If looking down on it, The knob on the right is now a silver barrel shaped and the side bars on the left are silver instead of red. So you could just print the trap and then customize it to GB2

    Any idea when you might get the Goggle metallic la[…]

    Be careful removing the Hasbro weathering using […]

    Are these autographs legit?

    This is over a month old, but none of the four sig[…]

    Charlesworth Dynamics Trap Build

    Hi All, The Trap is coming on, I've nearly finish[…]