User avatar
By Kodee-Wan
#4930260
I'm thinking about 3d printing a trap but I think I want to do a GB2 version to match my pack. Has anyone 3d printed this version? I have seen lots of GB1s floating around.
User avatar
By DarkSpectre
#4930285
There's minimal difference between the 2. If looking down on it, The knob on the right is now a silver barrel shaped and the side bars on the left are silver instead of red. So you could just print the trap and then customize it to GB2

    My bad, I didn't realize they went from top to bot[…]

    Has anyone had an issue with the wand tip not st[…]

    I was emailing Spongeface last night and mentioned[…]

    Whenever something big that I want to see happen […]