Ok posted all the videos i have. Sorry i am not a professional at taking or editing video. I have several photos i will post later. I took the whole front clip off because the bumper support was sheared off the car and had to be fixed. Also made it easier to work on the frontend. So right now its more of a dragto-1. And the exhaust is only two feet long so it is super loud. I also built my kid an ecto of her own.I was going to say the vehicle in the last video doesn't quite look or sound the same as the others
Awesome work, keep it up!
I'm not too familiar with all the different models of Cadillacs. Can you use any 1959 Cadillac front bumper for this swap? Can it be from a coupe or sedan or does it have to come from a 1959 commercial chassis Cadillac?
EDIT: Reading and looking closer at your post I guess you did a complete front end swap. Can this be done with any 1959 Cadillac? If you weren't going for such close authenticity, could you have just done a front bumper/grill swap?
No the 59 is different from the 61 so i had to swap the whole front end sheetmetal. I think you could swap the botten bumper onto the 61 but u would have to take the center bar and grill offactually, im very curious as to the doors on these cars, since so much of the front needs modifying to fit 1959 panels, whats the situation on the drivers doors? are they 1960 sedan doors or coupe doors or custom? its obvious that they arent 1961 sedan doors, what did they come off of?
Has anyone been using brickseek to find RGB figs l[…]
I'm a little confused. does the amplified sound bo[…]
So basically cutting the tube makes it more scree[…]
Oh boy, my shopping cart here keeps getting bigger[…]