[TheKevinShow]

The screws that come with the pack Clippard valve seem like they won’t be sufficient to secure it to the shell. Is there a specific alternative option that should be used?

What’s everyone’s preferred options for hardware to mount the GBFans electronics to a GBFans shell/mobo and a ThrowingChicken wand?

[abritinthebay]

They work great for me tbh. Tap the hole & add a nut if you really must but they’ve held for 12 years...

[TheKevinShow]

They work great for me tbh. Tap the hole & add a nut if you really must but they’ve held for 12 years...

Really? The screws look like they’ll be too short.

[abritinthebay]

I guess it depends on the thickness of your surface. I don't even have nuts tbh, I just tapped the holes.

[Ectotainment]

I replaced my clippard screws on the pack with 1 inch 10-32 socket cap head screws with lock nuts, my shell was also too thick for the clippard screws. The ones I had were silver, but I found a method on YouTube of baking them in wet coffee grounds to make them black. It worked pretty well, I had to repeat the process a few times to get them as black as I wanted.

[NotSabbat]

I havent had a problem with the stock screws on my wand Clippard, but the pack Clippard screws are replaced with socket cap screws (at least on the packs I used for reference) so I cant say how well it will hold on the pack side. My pack and wand are both 3d Printed with PETG if that matters to you.