"Have you or any member of your family ever been diagnosed schizophrenic or mentally incompetent?"
kahuna900 wrote: ↑May 25th, 2021, 11:34 pm When you posted this yesterday, I quickly checked the link on my phone and the link worked correctly for the 10ft length. I was going to check it again today on the PC to make sure but things went sideways real fast and I didn't have time to check until just now. Looks like it's still shows 10ft. Did they send you something else or did it actually say two 5ft sections?It read 10ft in the item description but Amazon ended up sending the same brand cable albiet the wrong size, and two in the package. I requested a return and bought the same cable, through the same link, and got the correct length this time
Ramsastro wrote: ↑June 8th, 2021, 3:27 am What did you use to fill in the hole where the wire originally came out of?
xan_theGBFan wrote: ↑June 17th, 2021, 5:08 pm Hey Kahuna, I'm trying to perform the power switch mod and it's giving me a headache. I believe my Rubies Ghost Trap is set up just little different than yours. Can you advise me how I should go about doing this?
NexBM wrote: ↑June 25th, 2021, 3:47 pm Okay, I'm going to apologize in advance because I am a complete novice and/or idiot when it comes to this stuff. The boards are different in the newer iterations of the Ghost Trap. I had to figure this out on my own at the time with plenty of trial and error.Thank you for this! I will give this a try and report how it goes
Sorry, no decent photos I can upload and I didn't want to pop open my ghost trap again for new photos!
You will need to relocate the board. I needed to at least. Mine is located in the lower middle section of the trap, inside between the wheels.
I de soldered the light from the board and soldered wires from the LED leads, to the positions they were in on the board itself.
For the power switch....(reference xan_theGBfan's photo https://imgur.com/a/0kYxqci) I believe I soldered a wire from the ON lead, to (1) of the board switch, and the OFF lead to the (3) of the board switch.
You may have to extend the speaker wires or replace them all together because I don't think they will reach once you relocate the board.
Like I said, this was a trial and error process for me and was also very tedious at times. Please ask me any questions so I can try and be more specific if need be. I wish I would have made a thorough post about this at the time with photo
xan_theGBFan wrote: ↑June 17th, 2021, 5:08 pm Hey Kahuna, I'm trying to perform the power switch mod and it's giving me a headache. I believe my Rubies Ghost Trap is set up just little different than yours. Can you advise me how I should go about doing this?Hey im currently doing my mod and got to stage of removing this from the board... Goj g to as a noob question. Whats best way to remove this/how to connect new switch to it(do i just use wires?)
Here is an image of my board.
Is there photos that show they used a waffle wea[…]
You know what would really kick ass for the series[…]
Looks like theres a pneumatic fitting and rubber[…]
That's how they are on the original plasma figures[…]