- June 18th, 2021, 1:17 pm#4950726
I've recently started on a BenOfKent Proton Pack build, which is something I've been interested in doing for a few years now. My only prior experience with anything like this was a Spirit Pack modification that I did last year while in lockdown (I'm in the UK). So far I've only finished the Clippard Valve and pre-drilled the holes on a few other pieces like the PPD, Crank Knob and HGA.
I have a question about the short loom that attaches to the top of the PPD. Some reference images that I've seen appear to show the loom coming directly out of the PPD. However other images seem to suggest a rod-like fitting coming out of the top of PPD, with the loom then connected to this fitting.
Can anyone advise on which way is correct please?
Thanks
I have a question about the short loom that attaches to the top of the PPD. Some reference images that I've seen appear to show the loom coming directly out of the PPD. However other images seem to suggest a rod-like fitting coming out of the top of PPD, with the loom then connected to this fitting.
Can anyone advise on which way is correct please?
Thanks