User avatar
By Gatchigirl
#4967748
I decided to go a different route with my Ecto Goggles. I looked up the AN/PVS-5a Night Vision goggles and noticed that the knobs on the side were different than what was used on the prop. So I went and made my own and just need some cleanup after I 3D printed them. Here's a couple of photos. Image and Image
ccv66 liked this
    Positron Props GB1 Pack Build

    Awesome!! Good luck on your build! Tom's shell i[…]

    Trailer posted for release for the Frozen Empire u[…]

    Trivia, callbacks etc I noticed so far *Cover A *[…]

    Matty Trap - Replace Pedal?

    Has anyone successfully transferred the pedal elec[…]