By graam
#4935317
Hey fellow GB fans!

I've made a template that was designed around BenofKent's pack kit. I got my kit in May 2020 so differences in sizes may occur. Also note the disclaimer below.

Disclaimer!!!!

Check the scale bar. It should measure 10cm.

Use at your own risk. These were made to be used with the Benofkent kit. My order was in May 2020. The measurements used as are based on that specific kit, so variations may occur on occasion.

Also, myself and Benofkent are in no way responsible for mistakes made when drilling. If you do uses these designs then check everything is where you want it before drilling any holes.

The circles are not sized to match the drill bit required.

To be printed on EU A4 paper

Image

Image

I posted the file on the BenofKent facebook page

https://www.facebook.com/groups/3644574 ... 611190869/
Dan AKA liked this

    My Little Pony/Ghostbusters crossover done by my d[…]

    Great work identifying the RS Temperature Control […]

    I read Back in Town #1. Spoilers : Hate to b[…]

    I'd really like to see the new t-shirt unlocks tra[…]