#4978305
Greetings,

Can the faux gas mask cover on the wand/ pack loom connector hose be removed and if so is there still loom under it or does this rubber cover part of the electronics? I had wanted to simply cut it off but I'm not planning on replacing it with the real thing I just want the pack to look more classic. Anyone done this?, any issues for the wand/ pack connection after via lights/ sounds interface issues?
#4978353
Thank you kindly Gentlemen. Did you guys just use some scissors or a hobby knife? I like the black tape over the residue left on it. I might keep that last part of the cover on and cut the rest of it off.

    Two more cameo appearances to add to the filmograp[…]

    I will have to check it out. All I could find was […]

    Ed’s 84 Pack Build

    I am copying every assembly technique you're using[…]

    Re. my previous post. I meant to say I haven't bee[…]