- February 4th, 2023, 4:46 pm#4978372
tobycj wrote: ↑February 4th, 2023, 2:48 pmI have seen your build thread already. I just wanted to see if there was a different way of doing it.Lyfie wrote: ↑February 4th, 2023, 12:29 pm How did you extend your trap cartridge so it over hangs? My BOK sits flush.If you have a look for my build thread on here you can see what I did with mine to extend it.
tobycj liked this
- February 4th, 2023, 4:47 pm#4978373
mike_waclo wrote: ↑February 4th, 2023, 3:51 pm There's a bolt that connects the cartridge to the outer shell... I put two extra nuts between the outer shell and the cartridge to space it out to look more GB1.Do you have a build thread for your trap? Or could you post some pictures of it so I can see please? Ideally pictures of the top of the trap.
- February 5th, 2023, 6:00 am#4978403
No build thread, unfortunately... But I just grabbed a couple of photos for you. Here's a shot of the inside of the trap cartridge, showing where the bolt attaches:
And here's a straight-down view of the gap between the cartridge and the outer body, where you can see the two nuts I used as spacers:
Lyfie wrote: ↑February 4th, 2023, 4:47 pm Do you have a build thread for your trap? Or could you post some pictures of it so I can see please? Ideally pictures of the top of the trap.
No build thread, unfortunately... But I just grabbed a couple of photos for you. Here's a shot of the inside of the trap cartridge, showing where the bolt attaches:
And here's a straight-down view of the gap between the cartridge and the outer body, where you can see the two nuts I used as spacers:
- By AlphagaiaYeah, let's not forget people don't just get the r[…]
GB2 Grey Suit Patch and Name Tape Location
- By fuzzjunkI tried searching and couldn’t find exactly […]
Hasbro proton pack heat sink
- By IamreadytobelieveThank you for your feedback and information on thi[…]
Need help coding Arduino for LEDs
- By prodestrianHoly crap! I just watched a couple of tutorials […]