By MeChANiClySM
#4996996
Hase anyone had success in taking apart the CRT Emitters inside the cyclotron lid of a Haslab proton pack?

I would like to paint the internals of them and I realized they are rubber sleeves, but haven't had success either in getting the sleeve to slide out through the bottom without damage, nor by prying off the cap of the emitters.

    Never used the foam. What I remembered doing was t[…]

    The hocus pocus is on my list of sets right now. I[…]

    did you ever get this suit and if so do you ha[…]

    Most people probably knew these already but I just[…]