[MayorLenny]

I made a post earlier asking the GB world if I should focus on upgrading a life size spirit pack, or start fresh with a Q Pack. Thanks for the replies. I decided to do a bit of both. I can already see I’ve bitten off off as much as I can chew! It’s my new end of summer project.

I’ve measured and printed ever-so-slightly scaled replacements using the Q pack files, so like I said, it’s a bit of a hybrid.

Improvements paid for, shipped and/or in progress:

-Tacobelli cyclotron/n-filter upgrade
-wire mesh for n filter holes
-HGA corner replacement & ion arm gap filler
-Cutting off booster tube and booster box. Not a small chore, but it’s got to go. It’s too wrong.
-Have 1mm black plastic sheeting to replace back wall where new booster tube will mount.
-Resin printed booster frame
-Booster/ion arm weld block
-Cut ion arm cap off, printed Q pack replacement, cut brass ion arm to place properly
-crank box cover/resin printed actual crank(volume)
-cut off pack Clippard, replacing with resin printed valve and fdm mounting plate
-vacuum port tube
-Ghostlab42 full light and sound kit
-Ghostlab42 vent relay
-Talentcell battery pack
-Wasteland Industries vent smoke kit
-6.5” slim mount speaker & 16ga wire
-Accurate cosmetic tubing and ribbon kit
-Resin printed brass fittings and legris elbows
-Charlesworth motherboard and metal ribbon clamp
-Motherboard mounts
-LC1 ALICE frame
-wand and pack labels from mobysign
-repaint, obviously(texture?)

-Spengler wand with proper ‘84 grips
-Fruttotechnology bargraph
-non split loom

-and whatever other odds and ends I come up with.

Now that I look at this list, it seems…a bit much. Oh well! Will let you know how it’s going.
Have a great day!

[MayorLenny]

It’s coming along…