#5001274
Hello everyone,

I'm in the process of modifying my 1:1 Spirit pack, and the next job I'd like to tackle is replacing the HGA and top-right corner with something more screen accurate.

I don't want to make a mess of it though, so if you've done this, would you mind giving me some guidance please?

Did you buy an off-the-shelf product or make something yourself? How did you fit it and get it to blend into the pack? Any tips?

I'm okay with cutting out as I've already done the Tacobelli cyclotron/bumper/n-filter replacement, but with that the new parts covered the cut out part. With the HGA, it's more exposed so I want to make sure I get it right.

I've seen this product on Etsy which looks pretty good: https://www.etsy.com/uk/listing/1713616 ... ize-spirit

Has anyone used that? Was it good?

Any help would be much appreciated!

    I might have some spares of the on/off switch I th[…]

    Isn't there a programmable mode for the lights and[…]

    Kenner 3D printed parts

    The doors require, if I remember correctly, disass[…]

    I'm in Turkey. I am looking for a clone too...but […]