By davidkram2003
#4895296
Hey everyone, I'm building a giga meter on my 3D printer and I have just about everything printed but I can't figure out a way to add the clear dome. What has everyone used for the done and where to get it. Thank you
User avatar
By Tyrael
#4895358
I'm assuming you printed the files I posted up on the Thingiverse? If so, I used the same domes AZSpidey did in his Gigameter build. They can be found here: https://kitkraft.com/products/3-1-2-88-9mm-clear-domes

By the way, I'd hold off on finalizing any build just yet. I'm redoing a few of the files to be easier to build the whole thing.
Cole Funstuff liked this
By davidkram2003
#4895359
Thank you for the info. I already finished printing everything and assembled it and just needed the dome to finish it. The only part I had trouble printing from those files was the microphone ears but other than that everything else came out great. Thank you for making those files available for everyone.
Tyrael liked this
    trekgod3's Spirit Pack build

    Nice build! 👍

    Depictions will vary, and that's clearly not the[…]

    Why not dump it into the toilet and flush it? The […]

    I thought it was a triangle with two snakes wra[…]