By azuma
#4919449
Hi GB fans,

Sorry for the dumb question. I recently bought Benofkent proton pack kits, and I need some advice on motherboard hole drilling. Asides from the placements of the holes? What is the suggested diameter for the holes? Can anyone give a hand? Thank you so much for your time.

Best regards,
Azuma

Image

Only xbox s and Xbox x, but not the original Xbox […]

Looking really good! After removing the cast N-fi[…]

NEW GB MOVIE SUMMER 2020!

I hope they are, because then they can report bac[…]

I basically had 3 issues with mating the GBfans sh[…]