User avatar
By Kodee-Wan
Supporting Member
#4930260
I'm thinking about 3d printing a trap but I think I want to do a GB2 version to match my pack. Has anyone 3d printed this version? I have seen lots of GB1s floating around.
User avatar
By DarkSpectre
#4930285
There's minimal difference between the 2. If looking down on it, The knob on the right is now a silver barrel shaped and the side bars on the left are silver instead of red. So you could just print the trap and then customize it to GB2

Hey all... I'm looking to add a few missing labels[…]

NYTF: Hasbro reveals Kenner Classics

They were up. I suspect it could have been a case[…]

MT500 Model for 3D Printing

Looks like you are doing a really good job so far!

Seconded, sounds interesting!