Have a guide or tutorial? Post it up!
User avatar
By Rvonvolen
#4942854
I'm working on my first pack right now, which will have a gb2 ribbon cable. My next build however will be much more accurate and have a gb1 cable, however I want to be able to make my own gb1 cable. Does anyone have any ideas on how to make a jig for it or any other way to make it?
User avatar
By Kingpin
#4945693
That's really not like asking if there's a DIY way to make a CPU. I'd be inclined to agree if the ribbon cable was being designed to be a functional element, but in the last 5-10 years some fans have been especially industrious when it comes to assembling ribbon cable replicas.

Sadly this is only a teaser video, the actual DIY video has yet to be uploaded... But this should give you a bit of an idea how to do a jig:



Though worst comes to worst, you could always buy one from Fincher Technologies.
NotSabbat, RedSpecial liked this
User avatar
By Rvonvolen
#4945696
Kingpin wrote: February 8th, 2021, 6:18 am That's really not like asking if there's a DIY way to make a CPU. I'd be inclined to agree if the ribbon cable was being designed to be a functional element, but in the last 5-10 years some fans have been especially industrious when it comes to assembling ribbon cable replicas.

Sadly this is only a teaser video, the actual DIY video has yet to be uploaded... But this should give you a bit of an idea how to do a jig:



Though worst comes to worst, you could always buy one from Fincher Technologies.
Thanks kingpin, I actually scored one for thirty dollars on etsy. I count that to be a lucky find because I've seen them go up as far as 90 dollars. Its actually a pretty good quality cable.
Kingpin liked this

    I was at work last night and did some reading up[…]

    Looking for this Slimer picture...

    Does anybody have a higher quality image of this p[…]

    Pedal Remix This part of the build has been[…]

    Had bought a spirit pack last Halloween for my son[…]