[RiverofSlime]

Greetings one and all, below is my 2017 Spirit pack with 2021 Hasbro Proton Blaster. Parts are mix of 3D printed, found objects, and fan-made. Based largely on GB2 photos but not intended to be 100% a "GB2 Pack."

A pack is never done so this is where I'm at...

[GBfan77]

Nicely done. What light kit did you use for the Blaster Wand?

[RiverofSlime]

Thank you! That's the GB Fans kit, which was a tight squeeze! I haven't wanted to open it up again since getting it all in there.

I purchased a 3D printer pretty much at the end of my build process so at some point I will probably print a different wand (and possibly a whole other full scale pack). Because I needed to bore out some of the internal parts of the blaster it didn't go back together as well as I would have liked. Specifically one of the screw posts from the top inside.

I learned a lot along the process and would definitely do it differently knowing what I do now.

[RiverofSlime]

Nicely done. What light kit did you use for the Blaster Wand?

Some different views:

[RiverofSlime]

WIP: Pics from newly installed tip: