[JL5-2020]

Hello I'm currently modding the leds on my neutrona wand and came across a dilemma. I used a dremel and replaced the top orange piece with an orange led and I wired that to the red slo blo led. I would like to add a warm white led to the same circuit but the led won't light (the led has been tested and works fine).

Is there a way I can do this or would I have to wire the led elsewhere?

[Nighty80]

White LEDs usually have a higher forward voltage; with the addition of the yellow LED (also higher FV than red) I suspect there’s not enough juice left to power it off the same circuit.

[JL5-2020]

That's what I thought as well. Right now the only circuit that makes it light is the board controlling the blinking white led and the vent light. I'm not to crazy about it lighting up with the vent but maybe I'll figure it out

Thanks for the reply