#4985993
As the title says, maybe anyone who owns a Legris Gen1 4mm elbow would chime in for some questions on measurements? Contact via PM also if you wish to do so.

I again state that I do not want to buy one, this is just to start a project and do some first tryouts so I need specific measurements of the elbow.

thx in advance!

PS: yes I know I've startet a similar thread in 2018 - but I've lost all my sketches :( so I was not able to connect the provided measurements (huge thanks to 910DOHEAD!!!) with them.
    When Did They Begin?

    Google has found these :: https://ghostbusterscit[…]

    Greetings from AZ!

    Thank you!!

    I recently read Aykroyd’s book and really en[…]

    Rancho Cordova, CA

    Anyone close by? I know there is a Sacramento fra[…]