|
The Booster Frame is the piece mounted to the face of the Booster Tube, often referred to as the "ladder". The original part was constructed from sections of a rubber floor mat, Dixon Ticonderoga pencils, and likely a piece of masonite for the main frame. The three "steps" in the middle feature a brick pattern on the surface.
*Resin cast replica by gb_dan |
|
This page was last edited by HoldinJohnson on March 9, 2010, 1:32 pm
Link to this page: http://www.gbfans.com/equipment/proton-pack/part-names/booster-frame/
Links Below This Category:
Proton Pack Part Names - http://www.gbfans.com/equipment/proton-pack/part-names/
Attenuator - http://www.gbfans.com/equipment/proton-pack/part-names/attenuator/
Booster Tube - http://www.gbfans.com/equipment/proton-pack/part-names/booster-tube/
Bumper - http://www.gbfans.com/equipment/proton-pack/part-names/bumper/
Crank Generator (Gearbox) - http://www.gbfans.com/equipment/proton-pack/part-names/crank-generator/
Cyclotron - http://www.gbfans.com/equipment/proton-pack/part-names/cyclotron/
Electrostatic Dissipation Assembly (EDA) - http://www.gbfans.com/equipment/proton-pack/part-names/eda/
Filler Tubes - http://www.gbfans.com/equipment/proton-pack/part-names/filler-tubes/
Hydrogen Gas Actuator (HGA) - http://www.gbfans.com/equipment/proton-pack/part-names/hga/
Injectors - http://www.gbfans.com/equipment/proton-pack/part-names/injectors/
Ion Arm - http://www.gbfans.com/equipment/proton-pack/part-names/ion-arm/
Ion Knob - http://www.gbfans.com/equipment/proton-pack/part-names/ion-knob/
Motherboard - http://www.gbfans.com/equipment/proton-pack/part-names/motherboard/
N-Filter - http://www.gbfans.com/equipment/proton-pack/part-names/n-filter/
Power Cell - http://www.gbfans.com/equipment/proton-pack/part-names/power-cell/
Primary Power Distributor (PPD) - http://www.gbfans.com/equipment/proton-pack/part-names/ppd/
Synchronous Generator (Spacer) - http://www.gbfans.com/equipment/proton-pack/part-names/synchronous-generator /
|
|
 |
|
