Tubing

Proton Pack Tubing {#proton_pack_tubing}

The actual tubing used on the pack is a contentious issue as are the sizes and lengths used. Here is a basic guideline:

5/32" Red tubing - 4 ft. needed

Installed from the Legris{.wikilink} elbow fittings on the HGA{.wikilink} and the Cyclotron{.wikilink} to the Legris{.wikilink} straight fittings below the PPD{.wikilink}. Also used between the two banjo fittings{.wikilink} on the gun tip{.wikilink}.

1/4" Blue tubing - 2 ft. needed

Installed from the back Injector Tube{.wikilink} to the Cyclotron{.wikilink}, from the PPD{.wikilink} to the base of the Dale{.wikilink} RH-50/Sage Resistors{.wikilink} M50W on the Ion Arm{.wikilink} and from the top of the RH-50/Sage ResistorsM{.wikilink}50W to the Clippard{.wikilink} elbow fitting on the top of the Ion arm{.wikilink}.

1/4" Red tubing - 3 ft. needed

Installed on the front Injector Tube{.wikilink} to the Cyclotron{.wikilink} and the Beam Line{.wikilink} to the Clippard{.wikilink} brass elbow on the HGA{.wikilink} (covered in 1/4" ID split loom)

1/4" Green tubing -1 ft. needed

Installed on the gun from the Clippard{.wikilink} brass barb on the rear instrument bar to the Clippard brass barb on the rear cylinder{.wikilink}.

5/32" Yellow -1 ft. needed

Installed on the Sage{.wikilink} 25 resistor on the Ion arm to the Legris{.wikilink} elbow fitting on the underside of the Ion Arm{.wikilink}.