Gizmo Belt

My first complete build for my uniform. I made the gizmo from a resin board that I had and then I built a wooden platform for the tubes. The tubes are real Nixie Tubes but they are from a old Mitsubishi circuit board not Sanyo. I saved the rubber housing and rubber error box so I could drill and place lights behind the tubes. The sister board is actually the circuit board that belongs with the LifeGuard inside. I needed the space inside the LifeGuard so I could place the three AA battery box. I ran a wire along with the belt so the sister board and Gizmo could get power. I extended the power switch to make contact with the belt so I can just move the LifeGuard to turn it off and on. I also made the holsters. The backs are from Home Depot and they are a tape and hammer holders. The Belt Gizmo holster is the tape measuring holder and I removed the straps and used a leather belt so the gap was gone and it made a tight fit. On the PKE holster is the hammer holder and I used the straps from the tape measure to use to hold the PKE. I used a mini leather belt to hold down the handle of the PKE and to keep it from falling off. I really enjoyed making them and I hope you guys like what I did.